PLAKEVENT - Event Flooring Tiles

The solid slab has a closed surface. The perforated slab has openings in its surface to allow water and air to pass through: it is recommended whenever soil drainage or aeration is important. Both versions have the same dimensions, the same height, and the same locking system.

The compressive strength is 130 t/m², measured over an area of 1 m² and certified by TÜV Rheinland and LGA. The actual load-bearing capacity always depends on the substrate and the load distribution: suitability for each specific application must be verified on site.

4 tiles per square meter, measuring 500 x 500 mm. One pallet contains 300 tiles, or 75 square meters.

No tools required. Before you begin, decide whether to lay the tiles in a 2- or 4-directional pattern: for a 2-directional layout, start with a single tile in one corner of the area; for a 4-directional layout, start with a 4-tile square in the center. Always hold the tiles by the locking tabs; the tile fits into the slots on the opposite tile, and the locking tab snaps into the groove. To remove, lift from the side with the hooks.

Yes, the tile is designed for both level and uneven floors. The recesses on the underside also ensure that it can be used in damp environments.

Yes: from -20 °C to +70 °C, and it is weather-resistant.

Yes. There are slots for universal ramps on all four sides, and both the ramps and the corners fit into place without any additional fasteners. If you’re installing with ramps, the installation must end with a full tile.